Reverse Power Protection Relay

Reverse Power Protection Relay


DIN rail mounting protection relays for use in single and three phase systems. Available in 55mm x 112mm or 100 x 112mm DIN rail cases.


For over protection, under protection and combined under & over protection available in AC current AC voltage & frequency versions. Millivolt trip, DC voltage trip, Reverse Power, Phase sequence & Phase balance relays also available in our extensive range of protection relays.

Selection Guide

M200-RP1Single or 3 phase 4 wire
M200-RP33 phase 3 wire

Typical Applications

The M200 reverse power relay is used to monitor the direction of power from A.C generators, if the current in the system being monitored is reversed, to a value greater than the customer adjustable preset limit the relay will energise. The adjustable trip point is 2% to 20% of input current. An adjustable time delay of 0 to 20 seconds is provided. Correct setting of the trip point and time delay, will ensure protection against motoring in the event of a generator failure and prevent tripping due to transients encountered during synchronisation. A red LED indicates the state of the relay and a green LED indicates the condition of the power supply.

Technical Specifications

Rated value Un57.8< 500V ±25%
Rated value InC.T. operated 1 or 5A or direct connected 0.2 to 10A
Burden<3VA voltage <0.5VA current
Overload1.5 x Un 2 x In continuous 2 x Un 10 x In for 3 seconds
RepeatabilityBetter than 0.5% of full span
Time delayAdjustable 200mS to 20 sec
AUXILIARYAll units self powered
WEIGHT&CASEApprox 0.6kg. 100mm case
Product CodeIn InputUn InputFreqOptions
M200-RP31 Amp400 Volt50Hz5 sec T/D


1Adjustable time delay max 30 seconds
2A.C. Auxiliary in range 57.7 to 480 volts
3Calibration at nominal Hz 35…450Hz
4Calibration at temperature other than 23ºC

Connection Diagrams

Call us now on: +44 1922 640003