D96-LSYNC LED SYNCHROSCOPE & CHECK SYNC RELAY |
Technical Specification |
| Input Voltage (Vn) | 440V (380/415V) +/- 20% |
| Optional Volts (Vn) | 110V (110/120V) |
| 230V (220/240V) | |
| Burden | 1.8VA max |
| Frequency Range | 40 - 65Hz |
| LED Specifications | As model D96 - LSYNC LED |
| Differential Volts | 0..20%...OFF Selectable |
| Range Normal | 0..30ºE Selectable |
| Time Delay Normal | 0..2 seconds Selectable |
| Range Kwik Sync | 0ºE +/- 2ºE Fixed |
| Time Delay Kwik Sync | 100mS Fixed |
| Roatation for Kwik Sync | Clockwise only (+slip) |
| Relay contacts | 1 Pole Changeover |
| Contact Rating | 8A @ 240V a.c. 30V dc |
| Humidity | 5% to 85% Non condensing |
| Temperature Range | -10...60ºC |
| Storage Temperature | -40...70ºC |
Adjustments and Settings |
| In addition to the 16 LED's used in the synchroscope there are 2 green status LED's | |
| 1) | The Diff.V LED will be ON when inside the preset limits. And OFFwhen just GEN voltages are applied |
| 2) | The relay LED will only be ON when the relay is energised. |
| The green LED at 0º geometric will be on between 358º...2º (0º +/- 2ºE) | |
| The Relay Mode will be factory set to customer requirements of Normal or Dead Bus and Diff set to 10%. Should the settings need to be changed i.e. to KWIK SYNC or a different Diff.V this is done by carefully removing the plastic front panel. | |
Ordering Information |
| Please Specify D96-LCSYNC on your order and normal or dead bus mode. (The synchroscope will operate on any input voltage 80-440V you do not need to specify voltage on your order.) |
Contact sales: sales@hobut.co.uk
